1. Secure and properly block the tires of vehicle on a level surface.
2. Jack up front of vehicle and install jack stands under frame behind the lower link rear brackets. Remove tires and front
shocks.
3. Remove the sway bar end link's lower bolts at axle housing on both sides, Lower front axle down until coil springs become
loose.
4. Now remove both coil springs. Remove upper bump stop
(use channel lock pliers working bump stop back and forth).
5. Remove bolt from inside bump stop cup. Install bump stop
spacer and original cup using 10mm x 50mm long bolts.
Reinstall factory bump stop.
6. Install 2" coil spring isolator pads on top of the factory pads. Raise jack up so that enough load is applied
to hold coil springs in place. Reinstall spring bolt and clip at bottom of left front coil. Install new shocks.
7. Reinstall Tires and completely lower vehicle to the ground. Now Reinstall and tighten the sway bar endlinks lower bolts
loosened from step #3.
REAR:
8.Jack up rear of vehicle and install jack stands under rear frame cross member. Remove tires and rear shocks.
9.Remove the sway bar end link's lower bolts at axle housing on both sides, Lower front axle down until coil springs become
loose.
10.Now remove both coil springs. Remove upper bump stop
(use channel lock pliers working bump stop back and forth).
11.Remove bolt from inside bump stop cup. Install bump stop
spacer and Install 2" coil spring isolator pads over original cup using 10mm x 50mm long bolts.
Reinstall factory bump stop.
12.Reinstall spring coil.Raise jack up so that enough load is applied to hold coil springs in place.
13.Install new shocks.
14. Reinstall Tires and completely lower vehicle to the ground. Now Reinstal and tighten the sway bar endlinks lower bolts
loosened from step #9.
NOTE: It is also Helpful to detach the rear track bar at the frame in order to lower the rear axle
